亚洲欧美日韩精品专区

Looking for partners to create wealth together 400-9155-118
Product Center Products
Current location: Home Page Product Center
Transparent waterproof adhesive for exterior wall
Transparent waterproof adhesive for exterior wall
Model:
Browse: Recently Two thousand two hundred and twenty-six Person view
product details

        Material introduction
Lindes external transparent waterproof adhesive is based on special polymer emulsion as raw material, synthetic rubber latex modifier, surface active agent, plasticizer and other refined polymer transparent, colourless exterior wall waterproof coating.
        Product characteristics
1, colorless, transparent, coating will not destroy the original wall decoration effect, do not return to appear yellow, clay and other phenomena.
2, heat resistance, UV resistance, ozone resistance, acid and alkali resistance, wide range of temperature adaptation.
3. The film has good film forming property. Soft and tough, it can resist the stress generated by the deformation and cracking of the base.
4, with water as the dispersion medium, non combustible, non-toxic, tasteless, and pollute the environment, is an environmentally friendly product.
5, cold construction, safe operation, convenient construction, can be directly sprayed, painted, brushed, scraped on the wall.
6. The membrane has microporous permeability and is suitable for the heat evaporation in the southern humid climate and is not agitated.
7, less consumption, low cost, permanent waterproof.
      Scope of application
1, all kinds of building external wall leakage waterproof repair.
2. It is applied to waterproof treatment of interfaces of various decorative materials.
3, all kinds of interior and exterior decorative materials surface waterproof, moisture-proof.
        Construction method
1, base cleaning: use detergent, wire brush, rag, clean the wall base as far as possible, but as far as possible, do not damage the original surface gloss.
2, brush the transparent waterproof glue brush on the wall, and finish the joint.
3, general brush 2-3 times, you should pay attention to the first time before coating the dry coating, do not stick to the hands and then coated again, and brush direction should be crisscrossed.
4. During construction, if it is too thick, it can be diluted with water, but the amount of water should be as low as possible.

Other products
400-9155-118