Li De Shi strong ceramic tile binder is a special polymerized waterborne polymer environment-friendly product. It is easy to use, water resistant and aging resistant. It has excellent adhesive properties. It is widely used in decorating materials, especially vitrified tiles, tiles, mosaics, marble and natural stone. It can effectively enhance the adhesive strength of the interface.
1, good flexibility, excellent anti-seepage, crack resistance, anti-aging performance, strong water resistance.
2. The bonding strength is strong, and after rolling on the surface of the vitrified brick and concrete substrate, the drawing strength is above 3.0Mpa.
3, the interface performance is excellent, after the inner and outer wall cement mortar is rolled and painted, it can achieve internal and external impervious water, effectively prevent the wall from being empty and not falling off.
4, easy to use, can be used directly, spray or roll coating.
A kind of Appearance: milky white liquid
A kind of Solid content (%): 54 + 1
A kind of Viscosity (mpa.s): 50~500
A kind of PH: 7~9
This product is used for interface treatment of internal and external walls, vitrified tiles, tiles, mosaics, marble and natural stone.
1, the specific dosage is related to the density of the base, loose and uneven base material is larger, otherwise smaller.
2, this product does not need to add water, can be used directly, single side brushing, about 0.1kg/
1. Base surface treatment: there is no need for floating dust on the base surface, no clear water and no grease affecting the adhesion of products.
2, the use of spraying or brush construction, for large area construction as far as possible the use of spraying mode, high efficiency.
3. For example, before painting or on the surface of old wall, it is only necessary to roll it directly.
4, paste vitrified tiles, ceramic tiles, etc., 2-3 hours in advance, stir the high strength adhesive evenly, then directly brush on the back side of the vitrified tile and wait for the table dry. Add 1/3 or so fine sand into the mortar after the surface is dry, then mix it with mortar, and rub the high strength adhesive on the top of the wall in advance.
Matters needing attention
1. Construction temperature should be above 5 C.
2, outdoor construction in strong wind and rainy days
3. The product has strong cohesive force, is not easy to scrub, and is prohibited from vitrified tiles and other surfaces.
4, for the use of surplus products, should be kept sealed, so as to avoid volatile components.
Packaging and storage
1. Packaging: 5KG 10KG 2KG 1KG
2. Store indoors at 5~35 C to avoid direct sunlight.
3. It can be kept for two years without opening.