A kind of Product description
Li De Shi home decoration moisture-proof interface agent is composed of special functional monomer imported emulsion, fine filler and a variety of additives by scientific processing of a single component of waterborne environmental protection interface processing materials. The product is mainly used for brushing on the base of a kind of composite board. Because of its strong permeability and adhesion, it can effectively bond the base layer and form a strong and dense net coating. It is strong, strong, tough, moisture-proof and alkali resistant. It effectively solves the problem of cracking caused by the dampness of the ceiling and the wall and the cracking caused by thermal expansion and cold contraction. The surface of the coating is coarse hook shaped, which can greatly enhance the adhesion between the substrate and the putty layer. Effective solution to the ceiling, lightweight skeleton partition, old and new plastering wall putty, latex paint off, empty drum problem.
A kind of Scope of application
The interface treatment of the top of the ceiling or wall surface before puting.
A kind of Grassroots requirements
A kind of Smooth, firm, no clear water, no oil stain, no dust, large cracks must be leveled and filled with cement mortar, and metal nails must be painted with antirust paint.
A kind of The moisture content of the wall base should be 8%, and the moisture content must be ventilated and dried.
A kind of Usage method
A kind of This product is a thick liquid liquid. After opening the barrel, stir it slightly, brush it evenly or brush it evenly, brush it two to three times (every time interval is about 3~6 hours), brush direction perpendicular cross, solid thickness should not be less than 1mm, the best thickness is 2mm. In case of excessive viscosity, add a small amount of water. The amount of water should not exceed 10%.
A kind of When brushing the product on loose substrate such as lime wall and calcium silicate board, it is recommended to treat the base with the help of lideshi all-purpose moisture-proof and solid wall, or dilute the product with 1:1 in clean water, then evenly spread it for one or two times until the white wall or loose base is fully absorbed until it is dried for 48 hours and then brush the product that is not mixed with water, otherwise it will cause delamination and cracking.
A kind of Reference dosage
2 x /kg (actual dosage depends on the level of base level).
A kind of Matters needing attention
A kind of Dust can not be painted on the base surface and must be cleaned before it can be painted.
A kind of This product is not suitable for special base treatment such as oil, plastic and glass. For example, for unidentified materials, please test first.
A kind of In order to achieve the effect of the product, putty performance needs to meet the relevant national and industry product standard requirements.
A kind of important clause
A kind of In practical application, the product is beyond the control of the manufacturer, and the company only assumes the responsibility of replacing the defective products. It is not possible to infer any legal liability of the company for its special purpose of application.
A kind of The company shall not be held responsible for any quality accidents caused by construction errors or failure to standardize construction according to product specifications and material requirements. In case of doubt or ignorance of construction method, please contact with us in time, and do not blindly construct.
A kind of Packaging and storage
1, packaging: 1L 5L 10L
2, store room with 5~35 C, avoid direct sunlight.
3. No seal can be kept for two years.